ultimaker cura - Anet A8 ignores extruder temperature? - 3D Printing Stack Exchange

I don't understand what's wrong with my G-code. I have set the printing temperature to 195 °C but when I try to print, the target temperature is always 0 °C and printing never starts. I have tried

How To Setting Panel In Cura Software, Anet A8 V2

More stable and precise: The X&Y-axis linear guide rail is made of high-quality aluminum, making it more stable and precise than the original brass

Creality CR 10 SE 3D Printer with Removable Bed and Auto Leveling, Effective Model Cooling Fan and Sprite Direct Extrusion, 600mm/s High-Speed

ultimaker cura - Writing G-code : swiping at start of print - 3D

Ecam Eurobot

creality ender 3 - Prints on bed are missing parts - 3D Printing

Cura 4.10.0 Pause at Height/Layer corrupts line width and layer

ultimaker cura - Anet A8 not printing over heat bed - 3D Printing

LOTMAXX Shark V3 FDM 3D Printer Auto Leveling, 3D Printing/Laser

ANYCUBIC Kobra Max 3D Printer, Large 3D Printer 450 x 400 x 400mm

Large Build Volume: Ultra-large forming volume allows you to print single model up to 300*300*340mm, or two of the same/mirrored model at the same

JGMAKER Large 3D Printer Artist-D IDEX Dual Extruder 3D Printers Direct Drive Extruder Linear Rail Large Build Volume 11.81x11.81x13.38in 98%

Anycubic Kobra 2 3D Printer, 6X Faster Speed Firmware

Tresbro Creality Official Ender 5 Pro 3D Printer with Silent

g code - What is a printer console/terminal? - 3D Printing Stack