What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t

Awesome Bambu X1C Upgrades You Have to Try!

Bambu Labs X1 Carbon

Bambu Lab X1-Carbon X1C Purge Poop Slide - Magnetic by erickson85

3d Printers South Africa, Page 171

My V2 and Bamboo lab X1 Carbon

Bambu Labs MMS (Manual Material System) by Imaginarydave - MakerWorld

Bambu Lab P1S Review: A New Standard for 3D Printing

Bambu labs x1-Carbon

The Best 3D Printers in 2023 – Buyer's Guide

thoughts on the bambu lab x1 printer? : r/3Dprinting

Bambu Lab P1S Review: A New Standard for 3D Printing