Cura generated code on CR-10; heats only bed and not nozzle; doesn't print - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Using Cura, I select my printer, CR-10 (1.1.6), the correct flavor, Merlin, verify that I have a temperature of 205 for the nozzle and 60 for the bed, and slice the file and save as gcode. When I attempt to print, the nozzle will heat correctly, but the temperature set point for the bed remains a

The Best Cura Plug-ins of 2023

On some models, the generated code causes the nozzle to crash into the print surface · Issue #7292 · Ultimaker/Cura · GitHub

Cura Settings Decoded – An Ultimaker Cura Tutorial - FacFox Docs

Creality 3DPrintMill(CR-30)- Belt 3D Printing For Everyone by Crealityofficial — Kickstarter

Creality Ender 3 V3 SE is not avalible in UltiMaker Cura under add Printer - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Nozzle randomly moves to the middle of the bed halfway into the print after every layer - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Creality Ender 3 V3 SE is not avalible in UltiMaker Cura under add Printer - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

I can't make clean holes when slicing with cura - UltiMaker 3D printers - UltiMaker Community of 3D Printing Experts

Cura is printing support on nothing? - 3D Printing Stack Exchange

The Best Creality Slicer Settings / Profile

Cura 4.11 not seeing my 20 x20 bed leveling test · Issue #10432 · Ultimaker/ Cura · GitHub