gcode experts - Software - LulzBot

Hello All, I have something I would like to try, but what I’ve tried so far doesn’t work (no big surprise really). If you look at the attached, I have tried: G1 X0 Y250 M226 and the head moves to X0 Y250 but no pause, it just moves right back and starts printing again. Has anyone tried doing this in gcode? Using KISSlicer BTW. Also, assuming I do get M226 to work, will sending another M226 resume printing? Is it like a toggle?

Editing Start and End gcode - Software - LulzBot

Cura: 3D printing software for your Lulzbot Printer - Tutorial Australia

Lulzbot Mini Critique

Slic3r Manual – Print Settings

LulzBot TAZ 6 3D Printer: : Industrial & Scientific

Cura LulzBot Edition v19

LulzBot Taz Workhorse Review: 10-Hour Testing

LulzBot Mini 2 – 3D Makers Point

Lulzbot Mini Critique

heated bed - Problem With large prints on Lulzbot Taz6 - 3D Printing Stack Exchange

LulzBot TAZ 6 3D Printer: : Industrial & Scientific

Building a Bioprinter as a High School Kid, by Yelim Kim

The 5 Best G-Code Simulators for Machining and 3D Printing