Extra Retraction at Start - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

CURA ultimaker Community

ultimaker cura - Extruder doesn't retract on inner wall lines thereby causing stringing - 3D Printing Stack Exchange

Welcome to Ultimaker Cura 3. – Septillion Co., Ltd.

Development of a high-performance open-source 3D bioprinter

5 Best Plug-ins for Cura

ultimaker cura - Extruder doesn't retract on inner wall lines thereby causing stringing - 3D Printing Stack Exchange

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Optimize retraction settings to prevent rework by hand after print - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

What Is The Best Free Software For 3D Printing?

Cura 2.7 strange retract behavior - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

print quality - Under extrusion when starting outer wall - 3D Printing Stack Exchange

Cura Combing Mode: What Is It and How to Use It

Printrbot Simple Metal Guide, College of Business

First Layer Retraction Settings · Issue #2476 · Ultimaker/Cura · GitHub

E3D Pathio Slicer vs Ultimaker Cura: Who Slices Better? – 3D Printer Power