Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Review Bambu Lab X1-Carbon 3D Printer First Impressions & Print Log - RC Groups

Bambu Lab P1S Desktop Organizer by 3DPrintsAndBeyond - MakerWorld

Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P

BambuLab

BambuLab

Bambu Lab X1 Carbon with AMS Review - 3DGearZone

Bambu Lab Slicer: Bambu Studio – All You Need to Know

Print Quality Issue, Overhangs, X1 Carbon, PLA - #22 by Rhotix - Bambu Studio - Bambu Lab Community Forum

Software Studio - Bambu Lab

Bambu Lab Slicer: Bambu Studio – All You Need to Know

Slow Down for Overhangs