Retraction right at start · Issue #9373 · Ultimaker/Cura · GitHub

Application Version Arachne_no_build_number_in_About Platform Mint 20.1 Printer Custom Reproduction steps Slice Save Open output GCode Actual results ;; LOOK NEAR THE BOTTOM OF THIS START CODE FOR THE ISSUE//QUESTION ;FLAVOR:Marlin ;TIME

ChangeAtoZ not adjusting retraction distances with relative extrusion enabled. · Issue #11487 · Ultimaker/Cura · GitHub

First Layer Retraction Settings · Issue #2476 · Ultimaker/Cura · GitHub

Cura is showing message unable to slice due to some per model settings. the following settings have error on ne or more models; Retraction Retract speed, Retraction Speed, Retraction Prime speed

New Feature: Support Retraction - Before and After · Issue #12731 · Ultimaker/Cura · GitHub

4.7.1) Pause at height isn't working with Ultimaker S3 5.8.1 · Issue #8557 · Ultimaker/Cura · GitHub

4.5.0] Firmware Retract Missing? · Issue #7295 · Ultimaker/Cura · GitHub

at the start of the slice it imediately failed to slice · Issue #17618 · Ultimaker/Cura · GitHub

Spiralize Outer Contour IGNORES all retraction · Issue #12498 · Ultimaker/ Cura · GitHub

Allow changing retraction speed/length/prime speed in ChangeAtZ · Issue #5321 · Ultimaker/Cura · GitHub