Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Hello   I have a part that i want to machine with rotary toolpath but my sinumerik post will post TRAORI - but my control throws an error with i get to that command.   I wanted just to do it without it and just X Y Z A g codes - my origin is in the center of the rotary.   I have been searching but the post if found about disabling TRAORI dident work for me.    Any help is appriciated    

Fusion 360 CAM Users

Solved: How can I enable the workpiece in Siemens Turning post processor? - Autodesk Community - Fusion 360

Stuck on submitting a render - Autodesk Community - Fusion 360

Post Library for Autodesk Fusion 360

Fusion 360 CAM Users

Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Rotary Module with Fusion360: It works! (good enough) - Snapmaker 2.0 - Snapmaker: where creation happens

Siemens 828d 3+2 machining with cycle800, custom post processor? - Autodesk Community - Fusion 360

Autodesk Fusion 360 problems - General Forum - VEX Forum

What causes Warning: Length offset is not supported.? [Sinumerik 840d post] - Autodesk Community - Fusion 360

Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Fusion 360 Help, Turning basics, Setup

Fusion 360 CAM Users

Solved: How can I enable the workpiece in Siemens Turning post processor? - Autodesk Community - Fusion 360

Fusion 360 + Sinumerik 840d