Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Bency test print on Ender 3X (Direct Drive) using PLA & Ultimaker

Extra gcode in the files from Cura. - UltiMaker Cura - UltiMaker

Using the Monoprice Voxel (FlashForge Adventure 3) With Ultimaker

Unnecessary start points ruining print, please help - UltiMaker

Ultimaker cura slices fine but on reading the gcode again through

Unnecessary retractions with Combing mode Off · Issue #4308

too much retraction at beginning - Improve your 3D prints

4.7.1] Max Comb distance with no Retract disables retraction

3D Print Zits & Blobs: 6 Tips to Prevent Them

analyze retractions and Z hop - UltiMaker Cura - UltiMaker

Coasting not applied on parts with only outer walls - UltiMaker

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Cura makes supports start on second layer, is there any setting to

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community