g code - What Setting In Cura Determines The Value Of G1 E-{switch_extruder_retraction_amount} At The Beginning Of A Print? - 3D Printing Stack Exchange

I am trying to print the Chep calibration cube sliced in Cura on my new Sovol SV04 Dual Extrusion printer. When I print the model the extruder prints the wipe line on the left of the bed, moves to

Beginners Guide to 3D Printing G-Code Commands

creality ender 3 - Cura variables and initial G-code commands - 3D Printing Stack Exchange

switched the cura starter gcode for the prusa one, led to crazy thicc extrusion. how do i recreate this in a more controlled way? : r/ender3

g code - How can I add an offset to the first layer to increase clearance? - 3D Printing Stack Exchange

Beginners Guide to 3D Printing G-Code Commands

ultimaker cura - Writing G-code : swiping at start of print - 3D Printing Stack Exchange

Why Do My Firmware's Retraction Settings Not Match Cura's Retraction Settings? : r/ender3v2

Retraction Amount of Extruder-switch

Beginners Guide to 3D Printing G-Code Commands