Poor Bed Leveling - Bambu Lab X1-Carbon - Bambu Lab Community Forum

I keep having fluctuations in the adhesion of the prints. Now on the Cool Plate. It went quite well over a few prints. Now the printer is starting to press PLA so hard onto the printing plate again that I can hardly get it off. Is the lidar to blame? Thanks for any suggestions!

Bambu Lab X1 Carbon with AMS Review - 3DGearZone

Bambu Lab X1 - Carbon Combo 3D Printer; 5 Color LCD Screen; Automatic Leveling; Bambu Cool Plate; 256 x 256 x 256mm - Micro Center

Bambu Lab X1 Carbon Review: Living In The Future

Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

Nothing but Issues since new firmware - #100 by Matt - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Poor print quality on one side of the bed only - Troubleshooting - Bambu Lab Community Forum

The Best CoreXY 3D Printers of 2023

Bambu Lab X1 Carbon with AMS Review - 3DGearZone

Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

The Bambu Lab P1S 3D Printer Review: Ultra-fast & Multicolor 3D Printing

Support says my print bed is close to acceptable deviation and they don't recommend waiting for new firmware rather than replacing it. The giant hunk of glass I am now using as